The raw wooden surface to be coated should be clean, dry, free from moisture ,dampness and other contamination

For hardwood, sand the surface using Sandpaper #80, followed by Sandpapers #120, #150, #180 and #220

For Veneer ply surfaces,start with Sandpaper #220

Always sand in the direction of the wood grain

Mix the base thoroughly prior to mixing with the hardener. Avoid applying in direct sunlight or when the humidity is very high.

Apply 2 to 3 coats of WoodCoat High Solids Sealer clear with an interval of 8 hours between the subsequent coats. Sanding should be done prior to the application of each coat

Sandpaper #220 can be used for the first coat and Sandpaper #400 can be used for the second and third coats

The number of coats of sealer required varies from 2 to 3 depending on the absorption of wood. Apply 2 coats of either WoodCoat Exterior Glossy clear or WoodCoat Exterior Silky Matt clear depending on the requirement. Sand the first coat with Sandpaper #600, after 8 hours of drying

MRF Woodstains Exterior shades can be used to enhance the colour of the wood grain. The available shades can be used over either the first coat or the second coat of sealer clear sanding of the applied shade is not permitted

For exterior applications use Woodstains exterior shades only

Conventional Spray, Nozzle orifice: 0.059 inches, Pressure: 35 – 45 psi

• Thinner Recommended – Thinner for finish