TreatWood Interior

• The raw wooden surface to be coated should be clean, dry, free from moisture ,dampness and other contamination
• For hard wood, sand the surface using sandpaper #80, followed by sandpapers #120, #150, #180 and #220
• For Veneer ply surfaces,start with sandpaper #220
• Always sand in the direction of the wood grain

• Mix the base thoroughly before mixing with the hardener.
• Avoid applying in direct sunlight or when humidity is very high.
• Apply 2 to 3 coats of Treatwood Sealer Clear, with an interval of 8 hours between subsequent coats. Sanding should be done before applying each coat. The number of coats may vary depending on the wood’s absorption.
• #220 sandpaper can be used for the first coat, and #400 sandpaper can be used for the second and third coats.
• Apply 2 coats of either Treatwood Glossy Clear or Matt Clear, depending on the requirement, with an interval of 8 hours between subsequent coats. Sanding after the first coat of topcoat should be done with #600 or #1000 sandpaper.
• MRF Woodstains Interior shades can be used to enhance the color of the wood grain. The available shades can be used over either the first or second coat of sealer clear. Sanding after applying the shade is not permitted.
• For interior applications, use Woodstains Interior shades only.

Conventional Spray, Nozzle orifice: 0.059 inches, Pressure: 35 – 45 psi

• Thinner Recommended – Thinner for finish