• The raw wooden surface to be coated should be clean, dry, free from moisure, dampness and other contaminants.
• For hard wood, sand the surface with sandpaper #80, followed by sandpaper #120, #150, #180 and #220.
• For veneer ply surfaces, start with sandpaper #220.
• Always sand in the direction of the wood grain. 

Application procedure:   

• Mix the base prior to mixing with the hardener.  
• DO NOT SHAKE THE CONTAINER. 
• Mix the base and hardener thoroughly before adding de-mineralised water.
• Avoid applying in direct sunlight or when humidity is very high.   

 Closed pore finishes:   

• Apply 2 to 3 coats of Aquacoat 2K PU Sealer Clear, with an interval of 8 hours between subsequent coats.   
• Sandpaper #220 can be used for the first coat, and sandpaper #400 can be used for the second and third coats.   
• The number of coats of sealer required varies from 2 to 3, depending on the absorption of the wood.   
• Apply 2 coats of Aquacoat 2K PU Glossy / Matt Clear, depending on the requirement, with an interval of 8 hours between subsequent coats. Sanding of the first coat should be done using sandpaper #600.   
• MRF Aquacoat Woodstains Interior Shades can be used to enhance the colour of the wood grain. The available shades can be used over either the first coat or the second coat of sealer clear. Sanding of the applied shade is not permitted.   

Open pore finishes   

• Apply 3 to 4 coats of Aquacoat 2K PU Glossy / Matt Clear directly on raw wood, with an interval of 8 hours between each coat.   
• Sanding should be done prior to the application of each coat:   
• Use sandpaper #400 for the first coat.   
• Use sandpaper #600 for subsequent coats.   

• Manual Brush Application
• Conventional Spray, Nozzle orifice: 0.059 inches, Pressure: 35 – 45 psi

• Thinner Recommended – Demineralised Water