Floor Coat
Aquacoat 2k Pu Is A Two Pack Water Based Polyurethane Clear For Wooden Floors
- 1LTS
Durability
Brightness
Gloss Resistant
Stain Resistant
Water Resistant
UV Resistance
Scratch Resistant
The raw wooden surface to be coated should be clean, dry, free from moisture ,dampness and other contamination
For hard wood, sand the surface using Sandpaper #80, followed by Sandpapers #120, #150, #180 and #220
For Veneer ply surfaces,start with Sandpaper #220
This step wise approach makes the surface smooth
Always sand in the direction of the wood grain
Mix the base prior to mixing with the hardener. DO NOT SHAKE THE CONTAINER.
Mix the base and hardener thoroughly before addition of de – mineralised water.
Avoid applying in direct sunlight or when the humidity is very high.
CLOSED PORE FINISHES
Apply 2 to 3 coats of Aquacoat 2K PU Sealer clear with an interval of 8 hrs between the subsequent coats
Sandpaper #220 can be used for the first coat and Sandpaper # 400 can be used for the second and third coats
The number of coats of sealer required varies from 2 to 3 depending on the absorption of wood
Apply 2 coats of Aquacoat 2K PU Floorcoat / Anti skid Floorcoat clear, depending on the requirement, with an Interval of 8hours between subsequent coats. Sanding of the first coat shall be done using Sandpaper # 600
MRF Aquacoat Woodstains shades can be used to enhance the colour of the wood grain. The available shades can be used over either the first coat or the second coat of sealer clear sanding of the applied shade is not permitted
OPEN PORE FINISHES
Apply 3 to 4 coats of Aquacoat 2K PU Floorcoat clear directly on raw wood with an interval of 8 hrs between each coat
Sanding should be done prior to the application of each coat with Sandpaper # 400 for the first coat and Sandpaper # 600 for the subsequent coats
- Manual Brush Application
- Conventional Spray, Nozzle orifice: 0.059 inches, Pressure: 35 – 45 psi
- Thinner Recommended – Demineralised Water
Floor coat / Anti-Skid Floor coat | 25 – 30% |