• Ensure that the surface is clean and free from dampness, dirt and other contamination. 
• Sand the surface using #180 sandpaper and clean thoroughly. Ensure that no loose particles are sticking to the wall. 
• For areas severely affected by algae and fungi, ensure that the surface is completely cleaned before initiating the painting process. 
• Freshly plastered surfaces must be allowed to cure completely. The coating process can be started after a minimum period of 30 days. 
• Available in matte and sheen finishes. (Application: Exterior Walls) 

For Interior Walls: 

• Apply 2 coats of Altura 2-in-1 Acrylic Emulsion with an interval of 4-5 hours between subsequent coats.
• Undulations in the wall can be leveled MRF VILASA Wall putty. 
• Putty should be used between the first and second coat of Altura Wall Primer and sanding of the putty shall be done as per recommendation. 
• Apply 2 coats Altura 2-in-1 Acrylic Emulsion with an interval of 4-5 hours between subsequent coats, after subjecting the second coat of Altura Wall Primer to sanding using sandpaper #320.
• Sanding of the topcoat can be done with sandpaper #600. 
• The number of coats of topcoats depends on the chosen colour. Darker shades may require additional coats.

For Exterior Walls: 

• Apply 1-2 coats of Altura 2-in-1 Acrylic Emulsion with an interval of 4-5 hours between subsequent coats.
• Sanding of first and second coat of Altura Wall Primer can be done with sandpaper #320.

Conventional Spray, Nozzle Orifice: 0.059 inches,
Pressure: 35-45 psi.

Thinner Recommended – Thinner for Finish (TFF)