• The raw wooden surface to be coated should be clean, dry, free from moisure, dampness and other contaminants.
• For hard wood, sand the surface with sandpaper #80, followed by sandpaper #120, #150, #180 and #220.
• For veneer ply surfaces, start with sandpaper #220.
• Always sand in the direction of the wood grain. 

• Mix the base thoroughly prior to mixing with the hardener
• Avoid applying in direct sunlight or when the humidity is very high
• Apply 2 to 3 coats of FRESHWOOD Exterior Sealer clear with an interval of 12 hrs between subsequent coats. Sanding should be done prior to the application of each coat. The number of coats varies depending on the absorption of wood
• #220 sandpaper can be used for the first coat and #400 sandpaper can be used for the second and third coats
• Apply 2 coats of either FRESHWOOD Exterior Glossy Clear or Matt Clear depending on the requirement, with an interval of 12 hrs between subsequent coats. Sanding after the 1st coat of top coat needs to done with #600 or #1000 sandpaper
• MRF Woodstains Exterior shades can be used to enhance the colour of the wood grain. The available shades can be used over either the first coat or the second coat of sealer clear.
• Sanding of the applied shade is not permitted
• For exterior applications use Woodstains exterior shades only

Conventional Spray, Nozzle orifice: 0.059 inches, Pressure: 35 – 45 psi

• Thinner Recommended – Thinner for finish