• Ensure that the surface is clean and free from dampness, dirt and other contamination.  
• Sand the surface using #180 sandpaper and clean thoroughly. Ensure that no loose particles are sticking to the wall.  
• For areas severely affected by algae and fungi, ensure that the surface is completely cleaned before initiating the painting process.  
• Freshly plastered surfaces must be allowed to cure completely. The coating process can be started after a minimum period of 30 days. 

• Apply first coat of Solvent Thinnable wall Primer and allow drying for 6-8 hours. 
• Smoothen the surface by filling dents with a thin coat of MRF Vilasa Wall Putty and allow drying for 4-6 hours. Sand the surface with emery paper No.220 and wipe clean. 
• Apply second coat of Solvent Thinnable wall Primer and allowing drying for 6-8 hours. 
• Sand the surface with emery paper No.320 and wipe clean. 
• Apply 2 coats of any MRF Interior Emulsion and Keep an interval of 4-6 hours in between two coats. 

Thinner Intake      -15-20%

Specific gravity     – 1.27 ± 0.03

Non Volatile Matter – 61 ± 2

Typical thickness   – 40-45microns/coat

VOC    –  <50 g/l

Recommended       – Thinner 555/MTO
Thinner

Method of application – Brush / Roller